Handle and jack
The tools needed to change the wheel are located in the trunk niche, behind the right rear wheel and the closed lid.
- Unscrew the red wheel and remove the jack.
- Install the handle on the jack. After use, fold the jack completely and remove the handle from the jack.
- Attach the jack to the brackets and screw on the red wheel
Spare wheel
The spare wheel is located under the bottom at the rear of the vehicle.
- Open the trunk door.
- Lift the cover and unscrew the nut that locks the spare tire support cable
- Stand behind the car and remove the wheel from under the car.
- Remove the retainer from the center of the spare tire
- Install the spare wheel in place in the reverse order of removal, positioning the wheel so that the valve is on top
Wheel replacement
- Place the vehicle on a level, horizontal surface with a hard surface.
- Apply the parking brake and engage first gear or, on vehicles with an automatic transmission, move the selector lever to the "P" position
- Remove the decorative cap from the wheel.
- Loosen the mounting bolts of the wheel being replaced, but do not remove them completely.
- There are platforms for installing the jack head near each wheel of the car. They are located at the level of the lower part of the body, near the wheels.
- To install the jack, use the platform located near the wheel being replaced.
- Install the jack and lift it by turning the handle. Make sure that the jack head is positioned on the designated area.
Opening the cover to access the jack
Loosen the nut that locks the spare wheel support cable
Attaching the retainer to the center of the spare tire before installing it in place
Using a wrench to remove a decorative wheel cover
Original version on our portal www.RenaultBook.ru
Installing a jack under the platform located near the wheel being replaced
Note: If the vehicle is on soft ground, place a small piece of wood under the jack.
- Raise the vehicle until the wheel is off the ground.
- Unscrew the wheel mounting bolts and remove the wheel from the vehicle
- Place the spare wheel on the center hub and rotate it so that the holes in the wheel disc align with the threaded holes in the hub.
- Screw in the wheel mounting bolts without tightening them completely. First, make sure that the bolts are free of rust and grease.
- Lower the car and remove the jack.
- Tighten the wheel mounting bolts in a diagonal sequence.
- Install the decorative wheel cover.
- After a short drive, check that the wheel mounting bolts are tight.
- Have the damaged wheel removed and repaired as soon as possible.
Caution: Never stand under a vehicle raised and supported only by a jack.