Removing
Disconnect the battery.
Remove the bolt (4) from the harness groove (5).
Set aside the chute.
Disconnect both connectors (9) injection computer.
Remove:
- nuts (7) injection computer mountings,
- injection computer.
Installation
Install the injection computer.
Torque tighten the nuts securing the injection computer (8 Nm).
Disconnect the two connectors from the injection computer.
Install the chute.
Connect the battery.
The spare part comes with an ECU in a non-working condition (or unprogrammed).
After replacing the injection computer, program the new unit using the scan tool.
Perform configuration and/or required programming.