Removing
Remove the intake silencer.
Disconnect connector (1) engine crankshaft position sensor.
Loosen two screws (2) mounting the crankshaft position sensor.
Set aside the mounting bracket (3) engine wiring harness.
Remove the crankshaft position sensor.
Installation
Install the crankshaft position sensor.
Install the engine wiring harness bracket.
Install the two crankshaft position sensor mounting bolts.
Torque tighten the crankshaft position sensor mounting bolts (8 Nm).
When replacing the engine crankshaft position sensor
Program the target area of the flywheel ring gear:
- decelerate with fuel injection cut off in 2nd, 3rd, 4th or 5th gears at 3500-3000 rpm for at least 2 seconds,
- decelerate with fuel injection cut off in 2nd, 3rd, 4th or 5th gears at 2400-2000 rpm for at least 3 seconds.
Verify with a scan tool that programming is complete.
Read fault codes.
Troubleshoot if necessary.
Delete trouble codes from memory.
Make sure the car is working.