Tightening torques | |
Throttle Position Sensor Mounting Bolts | 2.4 Nm |
Bolts of fastening of the case of the air filter | 9 Nm |
Removing
Remove the intake silencer.
Disconnect:
- wiring block (1) from the idle speed controller stepper motor,
- wiring block (2) from the throttle position sensor,
- pipeline system (3) trapping gasoline vapors.
Loosen two screws (4) attaching the air filter housing.
Remove the air filter housing from the throttle body.
Remove:
- both mounting bolts (5) throttle position sensor,
- position sensor (6) throttle valve.
Installation
Install:
- throttle position sensor,
- Both bolts hold the throttle position sensor.
Torque tighten the throttle position sensor mounting bolts (2.4 Nm) using the fixture.
Install the air filter housing.
Install the two air filter housing mounting bolts.
Torque tighten the air filter housing mounting bolts (9 Nm).
Attach:
- piping of the gasoline vapor recovery system,
- throttle position sensor connector,
- block of wires to the stepper motor of the idle speed controller,
- block of protection and switching.