Contents: Removal 🠛 Installation 🠛
Removal
- disconnect the negative battery cable;
- remove the ashtray;
- remove the center console;
Figure 8.81. Heating and ventilation control panel mounting screws
- remove the two panel mounting screws (Figure 8.81) and take it off;
Figure 8.82. Reverse side of the heating and ventilation control panel: 1– control cables; 2-pin connectors
- disconnect cables 1 from the panel (Figure 8.82), contact connectors 2 and drive cables from the levers of the turning mechanisms on the air distributor block.
Installation
1. Installation is carried out in reverse order. Install the panel along the guide pins.
2. Check the adjustment of the air distribution and shift flap drive cables.