Removing
Remove the engine top cover.
Disconnect:
- air intake pipe (1) on the air filter housing
- air pressure sensor connector (2) from the air filter housing.
Disconnect the mass air flow sensor connector (4).
Disconnect the intake air line (5) from the air filter housing.
Move the wiring harness away from the air filter housing.
Lift up the front of the air filter housing.
Slide the air filter housing to the left.
Remove:
- boost pressure sensor bolt,
- boost pressure sensor on the air filter housing.
Remove the air filter housing.
Installation
Check that the air filter housing mounting parts are on the EGR unit bracket and on the tabs.
Note: Replace studs if necessary.
Place the side of the air filter housing against the EGR valve bracket.
Move the air filter housing to the right.
Install:
- boost pressure sensor on the air filter housing,
- boost pressure sensor bolt.
Install the air filter housing by lowering it vertically on the injection side.
Install the air intake duct to the air filter housing.
Connect the mass air flow sensor connector.
Attach:
- wiring harness to the boost pressure sensor,
- air intake pipe on the air filter housing.
Install the engine top cover.