Vehicles equipped with a jack and wheel wrench
If necessary, remove the wheel trim, see section «Decorative caps, rims». Loosen the wheel bolts with the wheel wrench 4.
Install the wrench so that the applied force is directed downwards. Mark the nearest hole 1 of the corresponding wheel, the jack must be installed in this place. Position the jack 3 horizontally, placing the jack head 2 under the bottom of the body.
Turning the jack screw by hand, spread the jack so that the foot rests slightly under the vehicle.
Make a few turns until the wheel is off the ground.
Turn out and take wheel bolts. Remove the wheel.
Put the spare wheel on the hub and turn it until the mounting holes of the hub and the wheel match.
Tighten the bolts, making sure the wheel is correctly positioned on the hub, and lower the jack.
After the wheels are lowered to the surface, tighten the bolts firmly in order: 5, then 7, 9, 6 and finally 8, check the tightness (tightening torque 105 Nm) and spare tire pressure as soon as possible.