Tightening torques | |
Upper strut nuts | 21 Nm |
Lower strut mounting bolts | 21 Nm |
Removing
Lock the airbag computer.
Disconnect the battery.
Install clips (Ms. 583) in the zone (1).
Remove hose clamps (2) heater.
Disconnect heater hoses.
Remove:
- driver's frontal airbag,
- steering wheel,
- steering column switch assembly,
- dashboard,
- compartment for small items
- audio system
- dashboard.
Disconnect the wiring harness from the holder at the point (3).
Disconnect:
- wiring harness at point (4),
- connector (5) the ignition switch from the bracket.
Remove:
- screw (6) fastening the board of the relay of heating elements of interior heating,
- relay board for interior heating elements.
Disconnect wire connector (7) interior heating element.
Partially raise the floor mat to gain access to the strut mounting bolts.
Before removal, mark the position of the strut on the body.
Remove:
- both top nuts (8) strut mounts,
- both lower bolts (9) strut mounts,
- hydraulic cylinder
Substitute a container to collect the coolant.
Remove:
- two bolts (13) heater radiator mountings
- heater radiator pipe clamps (14) with a screwdriver.
Remove the heater core.
Installation
Always replace the gaskets between the pipes and the heater core.
Attention! To eliminate the possibility of leakage, before installing new gaskets, check the condition of the mating surface of the pipelines. The surface must be clean and without scratches.
Install the heater core.
Install:
- heater radiator,
- heater core bolts.
Attach pipelines to a heater radiator.
Establish collars on pipelines of a radiator of a heater.
Install:
- brace,
- both bolts of the lower strut mounting, observing the position of the strut marked during removal,
- both upper strut nuts.
Torque tighten:
- upper strut nuts (21 Nm),
- lower strut mounting bolts (21 Nm).
Lay the floor mat.
Note: Make sure the mat is placed under the accelerator pedal stop.
Connect the interior heating element connector.
Install:
- relay board for interior heating heating elements,
- screw securing the relay board of the heating elements of the interior heating.
Snap:
- ignition lock connector on the bracket,
- wiring harness on the strut.
Attach the wire harness to the retainers on the strut.
Install:
- dashboard,
- audio system
- compartment for small items
- dashboard,
- steering column switch assembly,
- steering wheel,
- driver's frontal airbag.
Install heater hoses.
Establish collars of fastening of pipelines of a radiator of a heater.
Remove clamps from hoses (Ms. 583).
Connect the battery.
Fill the engine cooling system with liquid.
Remove air from the engine cooling system.
Check the engine cooling system.
Unlock the airbag computer.