Removing
1. Remove the ashtray.
2. Unscrew bolts A and remove the ashtray holder (see illustration).
10.2 Unscrew bolts A and remove the ashtray holder
3. Unscrew two bolts In fastenings of the control panel of a heater. The bolts are located above the bolts A (see illustration 10.2)
4. Feed the control panel down and slightly remove it from the instrument panel.
5. Remove the lower terminal C and disconnect the fan speed control plug on the back of the panel (see illustration).
10.5 Remove the lower terminal C and disconnect the fan speed control plug on the back of the panel
6. Remove the retaining clips D from the rods by squeezing the leashes with a screwdriver (see illustration).
10.6 Remove the retaining clips D from the rods by squeezing the leashes with a screwdriver
Installation
7. Attach the tie rods to the damper arms.
8. Fix the rods in the clamps.
9. Connect the fan controller power plug.
10. Insert the control panel into the mounting location and secure with two screws.
11. Replace the ashtray holder and secure it.
12. Insert an ashtray into the holder.