Tightening torques, Nm
- Bolt and nut of fastening of an inlet collector 20
Removing
1. Remove the air filter.
2. Remove the fuel distribution rail.
3. Raise the car.
4. Remove bracket 1 (to access the bracket bolt on the right side of the car, remove the mudguard and right wheel).
5. Lower the car.
6. Remove the air duct A connecting the throttle body to the air filter.
7. Disconnect the throttle cable and electrical connectors 2 connected to the throttle body.
8. Turn out bolts and nuts 3 fastenings of a collector.
9. Turn out two bolts 4 fastenings of an arm to the block of cylinders.
10. Remove manifold.
Installation
1. Replace the intake manifold gaskets.
2. Installation is made in an order, the return to removal.