Removing
1. Moisten the windshield with water.
2. Turn on the wiper and let it run for a short time. Turn off the purifier. The cleaner brushes should return to their original position.
3. Mark the parking position of the wiper blades on the front glass. To do this, stick adhesive tape on the glass next to the brushes. During installation, the brush drive lever is put on the splines of the axis so that the brush is next to the glued adhesive tape.
As for the rear window cleaner, a label is applied on the glass at the top left, corresponding to the parking position of the brush.
4. Remove, prying with a screwdriver, the plastic cap of the lever axis.
5. Unscrew the lever mounting nut on the axle and remove the lever (see arrow in illustration).
39.5 Unscrew the nut securing the lever to the axle and remove the lever (see arrow)
Attention! The lever is removed from the axle by swinging the lever on the landing cone. If it is not possible to remove the lever in this way, then use the HAZET 1966-5 puller.
Installation
6. Put the glass cleaner lever on the axis, observing the parking position of the brush, and secure it with a nut with a spring washer. The tightening torque of the nut is 15 Nm.
7. Close the nut with a plastic cap.