Contents: Removal 🠛 Installation 🠛
Note: Before you begin, please read the Note given in Chapter 1.
Removal
1. The hydraulic pressure sensor is installed on the front of the transmission, at the bottom (see illustration).
10.1. Location of the pressure sensor in the automatic transmission hydraulic line (marked with an arrow).
2. To remove the sensor, apply the handbrake, then jack up the front of the vehicle and support it on axle stands.
3. Remove the mudguard from under the automatic transmission.
4. Disconnect the corresponding electrical wiring connector from the electronic control unit (on the left side of the engine compartment).
5. Loosen the mounting bolts and remove the sensor from the transmission.
Installation
6. Install in reverse order. Before operating the vehicle, confirm the wide open throttle position for the electronic control unit using the appropriate Renault equipment.
Original publication on the portal: www.RENAULTBOOK.ru