Share with friends:
Car steering system Renault Clio 1
Assembly of the steering gear without power assistance — removal, overhaul and installation
Note: A ball joint puller is required. Removal 1. Block the rear wheels, apply the handbrake, jack up the front of the car and place it on axle stands. Remove both front wheels. 2. Remove the nuts securing the ball...
Note: A ball joint puller is required. Removal 1. Block the rear wheels, apply the handbrake, jack up the front of the car and place it on axle stands. Remove both front wheels. 2. Remove the nuts securing the ball...
Power steering assembly — removal, overhaul and installation
Removal 1. Remove the battery ( Section 5A ). 2. Use special clamps to clamp the supply and return hoses near the power steering fluid reservoir. This will reduce fluid loss during subsequent steps. 3. Block the rear...
Removal 1. Remove the battery ( Section 5A ). 2. Use special clamps to clamp the supply and return hoses near the power steering fluid reservoir. This will reduce fluid loss during subsequent steps. 3. Block the rear...
Mechanical power steering pump — removal and installation
Models with D-series engines Note: When installing, the hydraulic line tube O-rings must be replaced. Removal 1. Loosen the three bolts securing the drive belt pulley to the pump, then loosen the drive belt tension (...
Models with D-series engines Note: When installing, the hydraulic line tube O-rings must be replaced. Removal 1. Loosen the three bolts securing the drive belt pulley to the pump, then loosen the drive belt tension (...
Electric power steering pump — general description, removal and installation
General description 1. On F3P engine models equipped with air conditioning, an electric power steering pump is used. 2. The operation of the pump is controlled by a pressure sensor in the pump outlet pipe and three or...
General description 1. On F3P engine models equipped with air conditioning, an electric power steering pump is used. 2. The operation of the pump is controlled by a pressure sensor in the pump outlet pipe and three or...
Power steering hydraulic system — bleeding
1. This procedure is necessary when any part of the hydraulic system has been disconnected or if air has entered the system due to a leak. 2. Remove the filler cap of the feed tank and bring the liquid level to the...
1. This procedure is necessary when any part of the hydraulic system has been disconnected or if air has entered the system due to a leak. 2. Remove the filler cap of the feed tank and bring the liquid level to the...
Tie Rod End Ball Joint — removal and installation
Removal Note: A ball joint puller is required. 1. Apply the handbrake, then jack up the front of the car and support it on axle stands. Remove the front wheel. 2. If the ball joint cannot be replaced, use a ruler and...
Removal Note: A ball joint puller is required. 1. Apply the handbrake, then jack up the front of the car and support it on axle stands. Remove the front wheel. 2. If the ball joint cannot be replaced, use a ruler and...
Tie rod and inner ball joint — removal and installation
Removal 1. Remove the tie rod end ball joint ( Chapter 23 ). 2. Cut the clamps and slide the steering gear protective boot off the steering rod. 3. Using suitable pliers, unscrew the inner ball joint of the tie rod from...
Removal 1. Remove the tie rod end ball joint ( Chapter 23 ). 2. Cut the clamps and slide the steering gear protective boot off the steering rod. 3. Using suitable pliers, unscrew the inner ball joint of the tie rod from...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Other sections on other Renault models
➽ Chassis, running gear: Steering Renault Laguna 2 (2001-2007)
➽ Chassis, running gear: Steering Renault Espace I and II (1984-1996)
➽ Chassis, running gear: Steering Renault Logan 2 (2012-2020)
➽ Chassis, running gear: Steering Renault Symbol 1 (1999-2008, petrol)
➽ Chassis, running gear: Steering Renault Fluence 1 (2009-2020, petrol)
➽ Chassis, running gear: Steering Renault Sandero 1 (2007-2012, petrol)
Link to this section in different formats
TEXTHTMLBB Code
- General information
- Maintenance
- Troubleshooting
- Power unit
- Petrol engines 1.1 l (C)
- Petrol engines 1.2 l (D)
- Petrol engines 1.2/1.4 l (E)
- Petrol engines 1.8 l (F)
- Diesel engines
- Overhaul of engines
- Cooling and heating
- Fuel system (carburetor)
- Central fuel injection
- Distributed fuel injection
- Fuel system (diesel)
- Starting and charging system
- Ignition system (transistor)
- Ignition system (electronic)
- Pre-heating of diesel engines
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Brake system
- Car suspension
- Steering system
- Body and interior
- Exterior (external elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits