Manual transmission specifications Main characteristics Type 4 or 5-speed (all forward gears are synchronized) and reverse, the differential is built into the transmission housing Designation Four-stage blocks JB0 or JB4 Five-stage blocks JB1, JB3 or JB5...
General description of a mechanical transmission 1. The manual transmission is equipped with four or five forward gears and reverse. All forward gears are synchronized. The main gear/differential unit is mounted in the transmission housing and is supplied with oil...
Gearshift linkage/mechanism adjustment 1. Apply the handbrake, then jack up the front of the car and support it on axle stands. 2. Unfasten and remove the mudguard from under the transmission. 3. Select 1st gear on the transmission by moving its operating...
Shift Rod/Mechanism — removal and installation Removal 1. While working inside the vehicle, push the gearshift lever cover away from the center console. 2. Apply the handbrake, then jack up the front of the car and place it on axle stands. 3. Working under the...
Speedometer Drive — removal and installation Note: On some later models, the speedometer drive is located on the right side of the transmission, just above the drive shaft. On such transmission modifications it is impossible to remove the drive. These models can...
Differential Drive Shaft Seal (Right Side) — replacement Note: You will need a ball joint puller, as well as a new O-ring shaft seal for the half-axis gear, new cylindrical pins for attaching the drive shaft to the half-axis gear, and a suitable sealant. 1. Apply the...
Reverse Light Switch — removal and installation Note: A new switch washer will be required during installation. Removal 1. Apply the handbrake, then jack up the front of the car and support it on axle stands. 2. Where applicable, unclip and remove the mudguard from...
Manual Transmission (F Series Engine) — removal and installation Note: This chapter describes the removal of the transmission without the engine, which remains in the vehicle. If you have a sufficiently powerful lifting mechanism at hand, it is recommended to remove the power unit...
Overhauling a Manual Transmission — general description 1. Repairing a manual transmission is a difficult task for a novice auto mechanic. In addition to the need to remove and install a large number of small parts, it will be necessary to accurately measure and, if...