Removal
After removal:
- rear aileron;
- windshield wiper arm (using the device E1e. 1552);
- tailgate trim;
- remove the side panels.
 |
 |
Disconnect the satellite antenna connector A, then remove it B.
Disconnect the connectors of the glass heater wires C, the connector of the antenna switch D.
Cutting off the glue layer
Using protective tape, cover the glass around the perimeter.
Pierce the glue layer at point 1.
Pass the glass removal string E under the edge of the lower holder.
Cut off the layer of glue at the bottom of the glass (1 to 2).
Do the same with the upper holder (3 to 4).
Installation
Observe the size of the glue layer.
Glue the windshield (together with an assistant).
Distribute the side gaps evenly.
Removal and installation of side glass of station wagons
Attention! The side window glass is installed using a holder.
The holder is not supplied as spare parts.
When removing and installing the glass, proceed as described below to avoid damaging the holder when cutting.
Removal
After removal:
- rear side shelf;
- side panel trim;
- rear light;
- using protective tape, cover the glass around the perimeter.
Pierce the glue layer 8 of the lower back with the braided wire.
Note: The punching tool should be inserted as close to the body panel as possible.
Install the holding device inside the vehicle, then the pulling handle on the outside (together with an assistant).
Pass glass removal string A under the edge of the lower holder.
Cut off the glue layer from B to C.
Pass the glass removal string under the edge of the holder from C to D, then cut off the adhesive layer.
Hold the glass from the outside, then finish cutting from point O to B.
Installation
Observe the size of the glue layer.