Disconnect:
- Wiper Motor Wiring Harness at Point (3);
- holder (4);
- spare connector (5).
Disconnect the windshield wiper motor connector (6).
Disconnect the central locking signaling connector (7) (if installed).
Disconnect the wiring harness (8). Loosen the nuts (9) and screws (10). Loosen the screws (11) and remove the box under the central part of the air intake niche (12).
Remove:
- wiring harness (13);
- fastening bolts (14) air ducts under the side parts of the air intake niche;
- air ducts under the side parts of the air intake niche (15).
Clean the foam padding on the duct under the grille of the air intake alcove and the joint surface. Replace the deflector foam pad under the intake alcove grille.
Install all parts in reverse order.