Attention! During operation, do not allow engine oil to get on the drive belts.
Removing
Remove the rigid air intake duct, unscrew the clamp 1 of the upper and the bolt of its fastening and the clamp of the lower fastening.
Place the car on a two post lift.
Drain the engine oil.
Remove the oil filter using the tool (Mot 1329) 3.
Installation
Lubricate the gasket of the new oil filter with oil.
Screw in the oil filter until the gasket contacts the surface of the engine.
Tighten the oil filter 3/4 turn by hand.
Install a rigid air intake pipe, wrap:
- top clamp;
- fastening bolt;
- bottom clamp. Fill the engine with oil.