SCENIC cars
Removing
1. Disconnect the stabilizer bar, see the relevant chapter.
2. Unscrew bolts 1. When removing only one rack, unscrew the bolts of only the corresponding rack (see illustration).
5.2 Remove screws 1
Attention! If all four bolts are unscrewed, then make sure that the steering gear does not move on the opposite side of the beam, because it is attached to the cross beam with the same bolts.
3. Unscrew bolts of fastening of racks to the bottom and remove racks.
If, after detaching the struts, it is necessary to use the steering mechanism, then the bolts I must be screwed in for this time and tightened with a force of 50 Nm.
Installation
4. Put the stiffeners in place and bolt to the bottom and the cross beam with a tightening torque of the bolts of 50 Nm.
Install the anti-roll bar.