A - Type of gearbox;
B - Gearbox index;
C - serial number;
D - Manufacturer;
E - Cutout if the gearbox is assembled with an E type engine;
F - The letter preceding all serial numbers over 999999.
Table 5.2. Technical data
Table 5.3. Materials used
Parts to be replaced when removed:
- cuffs;
- sealing rings;
- guide sleeve thrust release bearing;
- nuts of primary and secondary seam;
- speedometer drive gear;
- elastic pins of drive shafts;
- gear bearings.
Necessary special tools and equipment
- B.Vi 31-01 Barb set.
- Rou. 604-01 Wrench for hub nut.
- T. Av. 476 Ball joint puller.
- T. Av. 1050-02 Drive shaft puller.
- Support stand for the engine.
- Support stand for all aggregates.
Tightening torques, Nm
- Floating caliper mounting bolt: 40.
- Bolt of fastening of the holder of a cover of the hinge of a power shaft: 25.
- Lower control arm ball joint pin nut: 55.
- Bolt of fastening of the lower support of the shock-absorber: 180
- Engine tie rod bolt: 65.
- Bolt of fastening of a flange of a case of a gear box and a starter: 45.
- Subframe support mounting bolt on gearbox housing: 40.
- Wheel bolts: 90.
- Nut of fastening of a finger of the external steering hinge: 40.