Attention. To prevent problems from occurring (noise, premature wear, short circuit, etc.) after installation, mark the wiring harness route and the isolation of the connectors.
Unlock at the point (6) front door connector (1).
Disconnect:
- front door connector (1);
- speaker connector (2) front door;
- rear view mirror wiring harness (3).
Disconnect connectors (4) from the middle door handle.
Detach the clips (5) from the front door harness.
Remove the front door wiring harness.
Attention. To prevent damage during installation, make sure the wiring harness is not secured (holder, plastic tie, adhesive tape, non-disconnected connector, etc.).
Remove the front door wiring harness.
When replacing an old harness with a harness with a large number of taps, fix the unused wire blocks.
Install the front door wiring harness.
Close the front door harness clips at the point (5).
Connect the connectors.
Lock the front side door connector (1), by lowering the lock down to the stop.
Make sure the lock (6) sunk to the brim (otherwise a bad connection is possible).
Turn on the ignition.
Check the operation of all front door components.
Check the operation of all components that are controlled by the front door controls.