Removal and installation
1. Place the vehicle on a two-post lift.
2. Remove the battery.
3. Remove the injection computer bracket by disconnecting the 55-pin connector and the inertia switch connector.
4. Remove the nut 1 securing the power steering pipe and bracket A.
5. Remove the front right wheel.
6. Remove the drive shaft pin using rods B. Vi. 31-01.
7. Remove the upper bolt securing the shock absorber strut to the steering knuckle and loosen the lower bolt.
8. Move the steering knuckle to the side and disconnect the drive shaft from the gearbox.
9. Disconnect the wires from the starter, unscrew the mounting bolts and remove the starter from below.
10. Install in the reverse order of removal. Make sure the centering sleeve is present and should be at point B.
