Required special tool
- El. 1294-01 Wiper arm puller.
Removing the mechanism with an electric motor
1. Make sure the wiper arms are in their original position.
2. Open the hood.
3. Disconnect the battery.
4. Mark the original position of the wiper arms.
5. Remove the wiper arms using the Eld special tool. 1294-01.
6. Remove a lining of a lattice of an air intake of system of ventilation of salon.
7. Remove the air intake grille by first removing the two side decorative panels, two bolts and disconnecting the washer tube.
8. Turn away three fixing bolts A of the mechanism.
9. Disconnect the electric motor and remove it together with the mechanism.
Installation
Peculiarities
1. Before installing the wiper arms, make sure that their axles are in their original position. Clean the grooves of the wiper arm axles with a wire brush.
2. Install the wiper arms, placing the brushes in the position marked during removal.
3. Install new nuts and tighten them with a torque of 18 Nm (± 15 %) using a torque wrench.