Sunroof deflector
Open the sliding sunroof panel.
Turn away bolts (1) And (2), while supporting the sunroof deflector, and remove it.
Note. When removing and installing the sunroof deflector, apply high-strength locking compound to the deflector mounting bolt threads.
When replacing the sunroof deflector, replace the old mounting bolts with new ones included in the deflector repair kit.
Install the sunroof deflector operation is carried out by two people with an assistant).
Set the sunroof deflector return spring to the correct position.
Hold the sunroof deflector in place in the area (5).
Wrap the bolts (1), (2) And (3).
Torque tighten the sunroof deflector bolts 2 Nm.
Clear the area (6) deflector return spring with a lint-free cloth moistened with heptane. Wipe area (6) deflector return spring with a clean, dry, lint-free cloth.
Apply with a thin brush to the elements (6) lubricant for opening mechanisms.
Procedure for Initialization and Programming with Numeric Commands (in the absence of a diagnostic device)
Set the button to «sunroof closed» (the button is rotated counterclockwise to the leftmost position).
Press and hold the central part of the button: the sunroof moves to the closing stop, which is confirmed by a characteristic click.
After a characteristic click, continue to hold the button for about a second.
Release the button.
Immediately press the button again and hold it until the sunroof opens approximately ⅔ and then closes completely. Sunroof opening delay is normal (delay time approx. 5 seconds).
Release the button (sunroof operating again).
Note. If the procedure fails (too long delay between button presses or procedure interruption), you need to repeat it from the beginning.
Sunroof motor
In the event of a malfunction, the sunroof drive can be moved manually to the point (1) hex key.
Note. The sunroof control ECU is integrated into the sunroof motor.
Switch off the ignition.
Disconnect the battery. Remove the roof lining.
Disconnect connector (2) sunroof motor.
Loosen the mounting bolts (3) and remove the sunroof motor.
Sunroof panel
Open the sliding sunroof panel.
Remove the front screws (1) fixing the sliding sunroof panel.
Loosen the rear screws (2) fasteners and remove the sunroof sliding panel (3) (the operation is performed together with an assistant).
Using a lint-free cloth moistened with heptane, clean:
- guide rail (4);
- drive mechanism (5).
Wipe surfaces with a clean, dry, lint-free cloth.
With a thin brush, apply a thin layer of grease for opening mechanisms to the areas.
When installing, adjust the position of the sunroof mobile panel, the front of the sunroof mobile panel should be 2mm below the roof level.
Torque tighten the sunroof sliding panel mounting screws 6 Nm.
Sunblind sunroof front
Detach the holders (1).
Remove the sunroof front sunblind in the area (2).
Sunblind rear sunroof
Loosen the screws (3) and remove the rear sunroof sunblind.
Roof hatch gasket
Remove the movable sunroof panel.
Remove the sunroof seal (1).
Install the new sunroof seal so that the joint is at the center of the rear of the sunroof (2).
Glue the sunroof seal with a special glass glue.
Side moldings of the hatch of a cover
Before removing, protect the edges of the roof and windows with protective tape.
Remove the mechanism cover side seal from the sunroof rear side trim.
Be sure to pass the string between the sunroof side trim and the sunroof mechanism decorative seal.
Pass the string under the side lining of the sunroof.
Cut the bead of glue, from front to back, with a string with two handles.
Remove the sunroof front and rear side trims.