Contents: Removal 🠛 Installation 🠛
Removal
1. Release the parking brake.
2. Place the rear of the vehicle on jack stands.
3. Release the exhaust pipes in the area of the parking brake lever from the suspension mounts so that they drop down.
4. Unscrew the bolts securing the heat reflector shields A and B. Move shield B back and place it on the intake pipe (see illustrations 9.4 and 9.4a).
9.4 Unscrew the bolts securing the front heat deflector shield A
9.4a Unscrew the bolts securing the rear heat shield B
5. Measure and record the distance X from adjusting nut 1 to the end of the thread on the parking brake cable equalizer pin(see illustration). This will make subsequent adjustment of the parking brake easier.
9.5 Measure and record the distance X from adjusting nut 1 to the end of the thread on the parking brake cable equalizer pin
6. Unscrew nut 1 (see illustration 9.5).
7. Remove clamp 2 (see illustration 9.5).
8. Remove the center console box, see the relevant chapter.
9. Remove the parking brake indicator light switch and disconnect the connector (see illustration).
9.9 Remove the parking brake indicator light switch and disconnect the connector
10. Unscrew nuts 5 on the bottom of the car and disconnect the parking brake lever (see illustration).
9.10 Unscrew nuts 5 on the bottom of the car and disconnect the parking brake lever
Installation
11. Put the parking brake lever back in place and secure it with nuts 5 to the bottom (see illustration 9.10).
12. Place clamp 2 (see illustration 9.5).
13. Screw on the adjusting nut 1, installing the lining washer, according to the recorded distance X (see illustration 9.5).
14. Replace the parking brake indicator light switch and connect its plug.
15. Replace the center console box.
16. Adjust the parking brake.
17. Install and bolt the front and then the rear heat shields.
18. Secure the intake pipe to the suspension cushions.