Heating system control unit — removal and installation (Renault Clio 1)

Removal

1. The block is located on the bulkhead of the engine compartment (see illustration).

3.1. The heating control unit is installed on the partition.

2. Disconnect the negative cable from the battery.

3. Unscrew the fastening nut and remove the block from the bracket on the partition.

4. Disconnect the wiring from the base of the unit, noting the location of the connector.

Installation

5. Perform installation in reverse order, making sure that the electrical wiring connectors are connected correctly.

Original version on our portal: renaultbook

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Fedoseev Denis

Share with friends:

Clio 1: Pre-heating of diesel engines

Glow Plugs — removal, inspection, and installation
Pre-start and post-start heating system — description and testing
Pre- and Post-Glow System Specifications — diesel engines

After-heating microswitch — adjustment, testing, removal and…
Air Conditioner Microswitch — adjustment, checking, removal and…
Coolant Temperature Sensor — checking, removing, and installing
Fuel Filter Heating System — general description and component…