Removal and installation of interior trim (Renault Sandero 1)

The interior trims are removed if they are damaged or to gain access to other body components. Removing the center pillar trim is described in the process of removing the front seat belt (see "Replacing the front seat belts"), as it is an integral part of the belt removal process. This subsection describes the removal and installation of the front and rear pillar trims. The vehicle design does not provide for threshold trims.

Note: Left side trim removal is shown. Right side trim is removed in the same way.

1. To remove the front pillar trim, pull it towards you and separate it from the pillar, overcoming the elastic resistance of the clamps installed on the pillar.

2. To install the front pillar trim, place it on the clips and press on the trim until the clips snap into place.



3. To remove the rear pillar trim, disconnect the wire connector from the rear window heating element bus. Pull the trim toward you and remove it, overcoming the elastic resistance of the fastening clips.



4. Install the rear pillar trim in the reverse order of removal, pressing on it in the places where the fasteners are located until they are fully secured (click) in the holes in the pillar.

The text is available on this website [Renaultbook.ru]