Windshield wipers.
With the ignition on, turn the stalk lever 1 parallel to the steering wheel:
- A - off;
- B - intermittent mode. After each working cycle, the brushes stop for a few seconds;
- C - continuous operation at low frequency;
- D - continuous operation at high frequency.
When the ambient temperature is below zero, make sure that the wiper blades are not frozen to the glass, this can cause the wiper motor to overheat.
Windshield washers.
With the ignition on, pull the stalk lever E towards you.
Rear window wipers and washers
Rear window wiper with time delay relay.
With the ignition on, turn the end ring of the stalk lever 1 to the position where mark 2 is aligned with the corresponding symbol.
Rear window wiper and washer.
With the ignition on, turn the stalk lever 1 to the position where mark 2 is aligned with the corresponding symbol. If you release the ring, it will return to the position corresponding to the operation of the rear window wiper.
Attention! When the ambient temperature is below zero, make sure that the wiper blades are not frozen to the glass, this can cause the wiper motor to overheat.