Removing
20. Remove the doorway seal near the B-pillar.
21. Remove button 1 of the seat belt height adjuster using a flat screwdriver (see illustration).
28.21 Remove button 1 of the seat belt height adjuster using a flat screwdriver
22. Unscrew a bolt of fastening of the top bracket of a seat belt.
23. Detach the top of the lining by releasing it from the latches A and B, and then move it slightly towards the trunk to release the window seal (see illustration).
28.23 Detach the top of the lining by releasing it from the latches A and B, and then move it slightly towards the trunk to release the window seal
24. Release the lower end of the pad from the retainer D and lift it up to remove it from the seat belt slot (see illustration 28.23).
25. Remove the upper part of the vent lining by unscrewing the screw A, and then pushing the trim down (see illustration).
28.25 Remove the upper part of the vent lining by unscrewing the screw A, and then pushing the trim down
26. Remove screws E and F (see illustration).
28.26 Remove screws E and F
27. Disconnect a wire of a heater of back glass.
28. Submit forward and remove the pad near the glass of the tailgate, releasing the seat belt from the pad.
29. Remove the lower lining of the window by disconnecting the seat belt. To do this, unscrew the bolt securing the lower belt bracket (see arrow in illustration).
28.29 Remove the lower lining of the window by disconnecting the seat belt (see arrow)
30. Unscrew the screw E fastening the guide G of the front seat belt tape, and then feed the guide vertically forward, releasing its end H (see illustration 28.29).
31. Remove screw 4 (see illustration 28.29).
32. Release the pad from the clamps C, D and E and disconnect at point F (see illustration).
28.32 Release the trim from the clamps C, D and E and disconnect at point F
33. Unscrew the handle 6 opening the window (see illustration).
28.33 Unscrew handle 6 for opening the window
34. Remove three screws 5 (see illustration 28.33).
35. Unscrew the lock R of the seat back (see illustration 28.33).
36. Remove the window trim.
Installation
The installation of the removed parts is carried out in the reverse order of removal.
Attention! The seat belt anchor bolts are tightened to 25 Nm.